[PC] Practice Problems 01 | Part 01 of 01

Physical connection of pipes between two separate building water supply pipes.

The length of a pipe along its centerline and fittings.

A water supply pipe connecting the fixture with the fixture branch.

A bathroom that contains toilet, lavatory and shower stall.

The end of a pipe which fits into the bell.

The lowest portion of the inside of any pipe.

Denoted by its outside diameter.

Automatically closes to prevent water in reverse direction.

The extension of a soil or waste stack above the horizontal drain connected to the stack.

A fitting or device constructed to prevent the passage of air and gas.

Approve plumbing fixture to receive discharge from indirect waste pipes.

Vertical distance between the dip and the crown weir of the trap.

A vent that serves two traps on the same level.

Outhouse structure used in deposition of excrement.

A group vent extending in front of the last fixture to the vent stack.

An accumulated vessel to discharge pre-determine quantity of water for bushing purposes.

Approved tank or pit which receives sewage located below normal grade.

Hemp or old hemp rope soaked in oil or tar to make it waterproof.

A minimum standard quantity of plumbing fixtures that discharges wastes into a plumbing installation.

The pressure existing without any flow motion.

An open return bend usually made up two 90 deg. bends with inside and outside threads, flanged or welded fittings.

A pipe which conveys potable water from the building supply pipe to the plumbing fixtures and other water outlets.

A pipe within the structure or on the premises which conveys water from the water service pipe or meter to the point of utilization.

Any joint or seam obtained by the joining of metal parts in a plastic molten state.

An air pressure less than atmospheric. Also, implies siphonage in piping system.

A vertical pipe, or a reservoir, into which water is pumped to give it a head.

A water supply pipe which extends vertically to one full storey or more to convey water into pipe branches or plumbing fixtures.

The vertical main of a system of soil, waste or vent pipings extending through one or more stories and extended through the roof.

Apprentice of Master Plumber.

Void between pipes and sleeves through concrete floor in the ground shall be appropriately sealed with _____.

Which of the following is normally installed as an indirect waste?