📝 [MP] QB ID: 0517141319040417 | Weekly Exam 01 – Plumbing Code

The distance of water closet or bidet center to center:

Code on Sanitation of the Philippines:

Voids between pipes and sleeves through concrete floors in the ground shall be appropriately sealed with _____.

Elastomeric gasketed and rubber-ring joints shall comply with _____ installation standard.

Who is the current chairman of the Board of Examiners for Master Plumber?

All plumbing plans, drawings, diagrams, etc. shall be submitted in _____ sets for permit application.

A plumbing permit shall become null and void if the plumbing work has been suspended or abandoned for a period or _____.

In a plumbing unit, how many floor drains are included?

Date of the Accreditation of NAMPAP:

ASTM means:

What is not included in a plumbing unit?

Which authority is responsible for the administration and enforcement of the National Plumbing Code?

The Old Fire Code of the Philippines:

The Plumbing Code has been in existence for almost _____ since its promulgation before it has been amended.

Copper tubing shall be fully externally protected with a/an _____ and fiberglass wrapping installed inside a split rigid casing whenever installed underground.

Wiped lead joints shall have an exposed surface on each side of a joint not less than _____.

For caulked-on closet ring, the minimum overall depth shall be:

A hose connection with two-gated outlets permitting two connections of the same or smaller coupling diameter to be taken from a single supply line:

Each member of the board, shall at the time of his appointment be at least _____ of age.

A registered master plumber must not supplant another Registered Master Plumber after definite steps have already been taken toward his/her being commissioned to perform the contract:

The Administrative Authority must be notified at least _____ working days before such inspection is intended.

A pipe or conduit for carrying sewage and wastewater:

Tube made of plastic material and colored black. The cross-sectional shape is normally oval and is denoted by its outside diameter (O.D.):

Trap arm size of Laundry Tub:

Color for Type M copper pipe:

An adjustable tubing connection, consisting of a compression nut, a friction ring, and a compression washer, designed to fit a threaded adapter fitting or a standard taper pipe thread:

What is the accreditation number of NAMPAP?

IPS shall be supported at _____ intervals for piping 19 mm diameter and smaller.

This examination subject in Master Plumbing was originally split into two:

Minimum weight of a lead for flashing or vent terminals:

Depth of the molten pig lead in a caulked joint:

What will happen if a drainage piping is placed at slope of 10mm/m due to structural conditions?

The year when NAMPAP was organized and registered with the Securities and Exchange Commission:

An open return bend usually made up of two 90° bends:

Common maximum service temperature rating of PVC:

(ANSI) Pipe Color code for Fire Quenching:

A pipe flange that is not drilled for bolt holes:

Each fixture directly connected to the drainage system shall be equipped with a _____.

The birth of the plumbing profession in the Philippines is traced back to the _____ century.

A water heater is classified as:

Vertical support of _____ is placed not less than every other storey height.

The top edge of a receptacle from where water overflows:

Integrated within an air accumulator vessel which is designed to discharge a predetermined quantity of water into fixtures for flushing purposes:

1 fixture unit is equal to:

Preferred when a piece of pipe needed is shorter than 150 cm long:

Distance of bottom of all pipe tranches to the footing of any adjacent building or structure parallel to it:

Every building where _____ shall have a sewer service connection to a public or private sewer systems.

What section of RA 1378 enumerates the qualification for persons applying for examination?

Any change, addition or modification in construction or occupancy:

Copper tube for water supply piping shall have a weight of not less than _____.