📝 [PC] QB ID: 00020204110417001904 | BEP 02

Devices which discharge clear wastewater into the building drainage system shall discharge through _____.

Where a public sewer is available in the area, the owner has the right to construct a private sewage disposal system if he or she so demands.

When floor drain is subject to reverse flow of sewage or liquid waste, such drains shall be equipped with an approved _____.

Siamese connection with 125 mm diamteter.

Expansion loop is used in what kind of piping system.

It is a small amount of pipe exists between the threads of a pipe, it is called a short nipple. Its other name is _____.

Restaurant and other special use sinks may be made of approved type bonderized and galvanized steel sheet of not less than _____.

All plumbing plans, drawings, diagrams, design analysis/computations as required, technical specifications, bill of materials and other documents for all types of occupancy shall be prepared, signed and sealed by a registered and licensed master plumber, _____.

Cesspool may be permitted for use when first approved by the administrative authority and where it is established that a public sewer system will available in less than _____.

All whirlpool bathtubs shall comply with the following requirements, except _____.

Size of thrust blocks shall be based on the following, except _____.

No excavation for a seepage pit shall extent within how many meters of the water table.

In lieu of upper terminal cleanout for building drain/sewer, what can be substituted?

All drainage piping shall clear domestic water supply wells by at least 15.2 m, but the distance may be reduced to not less than how many meters when the drainage piping is constructed of materials approved for use within building.

Where permitted by the rules and regulations of the DENR, a building sewer may be connected to a private sewage system complying to its provision and shall be determined on the basis of the following EXCEPT _____.

An exemption to independent system is that building drain from the front building may be extended to serve the rear bldg. if _____.

Required horizontal clearance of clean-out from an access door, trap door, or crawl hole.

Which of the following situations/locations do not require a clean-out?

The developed length between the trap of a water closet or similar fixture measured from the top of closet ring to inner edge of vent shall not exceed _____.

When floor drain or similar traps are subject to infrequent use, what device should be provided/installed?

Color code of PVC tube used for sanitary drainage system.

Which of the following parts of an elevated or gravity storage tank is not required to be screened.

Consists of two independently acting internally or externally loaded check valves, four properly located test cocks with connectors and two isolation gate valves.

FS for plumbing specification stands for _____.

In conducting water test for water piping, it shall be tested and proved tight under a water pressure of how much percent of the working pressure?

Maximum number of fixtures allowed to be connected into any grease trap.

Do we need to provide clean-out for pressure drainage system?

Vent pipe opening from a soil or waste pipe shall not be below the weir of the trap except for what fixture?

Cleanouts shall be designed to be gas and watertight without the use of any _____.

Minimum vertical extension of VSTR/SVTR above the roof.

Shall have an outside protective coating of an approved materials, machine, applied and conforming to recognized standards.

Which of the following can be drained through an air break?

When it is found impractical, building/street sewer may be have a slope of not less than 0.5% provided that such piping shall have a diameter of not less than _____.

Which of the following requires the installation of grease interceptor?

Minimum height of yoke vent connection with the vent stack above the floor.

Flag-poling of vents may be allowed provided that the roof is used for purposes other than for _____.

Maximum stories able to serve by a single yoke vent.

Maximum length permitted for a fixture tailpiece.

IAPMO stands for

A test to determine the absorption rate and qualities of soil for a septic drain field or leaching field.

Hydro-pneumatic pressure tank, or an elevated tank and booster pump shall be provided, whenever the water pressure will not provide at least _____.

Minimum weight of copper tubes used for underground drainage.

Excreta drainage pipe that is only allowed to be used above ground.

One trap may serve a set of what fixture installed immediately adjacent to each other.

A room or space having a volume less than 1.4 cu.m. with 250 kilogram calorie of the aggregate input rating of all fuel burning appliances installed in the space.

Venting system installed for island fixtures directly connected to the drainage system.

Public sewer may be considered as not being available when such public sewer or any exterior drainage facility connected thereto is located more than how many meters from any proposed building?

No dishwasher drain shall be connected to a sink, tailpiece, continuous waste or trap or the discharge side of a food waste disposal system.

Copper tubing shall be fully externally protected with bitumastic coating and fiberglass wrapping and installed inside a split rigid casing whenever installed _____.

Water pipe joints shall be installed not less than how many meters away front sewer line in both direction?